Authors: Yong Zhang1,Nicolas Labrosse1,Susanna Parenti2, and Therese A. Kucera3
Affiliations:
1SUPA School of Physics and Astronomy, University of Glasgow, Glasgow G12 8QQ UK
2Université Paris-Saclay, Université Paris Cité, CEA, CNRS, AIM, 91191, Gif-sur-Yvette, France
3Heliophysics Science Division, NASA Goddard Space Flight Center, Greenbelt, MD, 20771 USA
<< previous nugget — next nugget >>
Introduction
On 15 April 2023, Solar Orbiter’s Spectral Imaging of the Coronal Environment (SPICE) instrument [1] performed its first dedicated off‑limb observation of a solar prominence. The event was observed in the pre‑eruptive phase (07:03–08:09 UT) and later erupted around 10:00 UT. SPICE measured the hydrogen Lyman β (102.57 nm) and Lyman γ (97.25 nm) spectral lines. These lines are emitted by neutral hydrogen from the n=3 and n=4 levels to the ground state, with formation temperatures around a few 104 K, making them excellent diagnostics of the cool plasma that constitutes prominences [2]. In this nugget, we summarise the observational findings, including a simple geometric method to estimate the radial velocity of the erupting filament from 2D images.
Figure 1: The SPICE observation of the integrated intensity of the Lyman and Lyman lines taken from 07:03:40 – 08:09:23 UT on 15 April 2023.
SPICE observations of Lyman and Lyman
The prominence was a large quiescent structure in the northern hemisphere. Figure 1 shows the integrated intensity maps of Lyman and Lyman before the eruption. The prominence appears as a structured region between the solar disc (bright) and the corona (dark). The ratio of Lyman to Lyman integrated intensity is roughly constant (~2.5) across the disc and prominence, indicating similar line formation mechanisms in the two regions. In the corona the ratio scatters widely due to low signal‑to‑noise. The green cross in Figure 1 marks the position of maximum intensity in the prominence along the blue cut, and the red cross marks the position of maximum intensity in the disc region along the blue cut.

Figure 2: SPICE observation of the Lyman integrated intensity from 08:13 to 11:58 UT, 2023 April 15. ‘PR’ is the abbreviation of ‘prominence region’.
During the eruption (Figure 2, Lyman β only, as Lyman γ was not observed), the integrated intensity in some parts of the prominence becomes even brighter than the solar disc, suggesting enhanced heating or increased column density. However, other erupting parts show lower intensity and narrower line widths, likely due to lower density.
Line widths and line profiles
We measured line widths using the quantile method, which is robust against noise and asymmetries. Before the eruption, the intrinsic line widths (corrected for the SPICE instrumental broadening) are 0.10 nm (Lyman β) and 0.16 nm (Lyman γ) in the prominence, similar to disc values (0.09 nm and 0.13 nm). During the eruption, the intrinsic widths of the Lyman β line in both regions become ~0.05 nm. These values are notably larger than those reported for quiescent prominences from SUMER, suggesting that prominences that are close to eruption may have different plasma conditions. However, remaining uncertainties in the SPICEoint spread function may also contribute.
The spectral profiles (Figure 3) show that the eruption enhances spatial and temporal variations in line intensity and line‑of‑sight motions, reflecting dynamic changes in the prominence plasma. By using the quantile method, we found that most Doppler shifts are below the SPICE resolution limit (~30 km s⁻¹).

Figure 3: The Lyman β and Lyman γ profiles in the prominence before the eruption (upper four rows) and Lyman β profiles during the eruption (lower two rows) from SPICE observation. Colored dots mark the cumulative distribution function (CDF) = 0.12 (blue), 0.50 (green), and 0.88 (red) positions. Red dashed lines show the reference line centers derived from the quiet‑Sun disk average (shift = 0).
A new method to estimate radial velocity from 2D images
Radial velocity is an important input for radiative transfer models (e.g., for Doppler dimming), but it is difficult to measure directly from SPICE spectra at the available resolution. We developed a simple geometric method that uses two 2D images of the erupting filament observed by a single instrument.
First, we assume the eruption is radial – a reasonable assumption because 75 % of filament eruptions are radial [3]. Second, we assume uniform acceleration over the short time interval between the two images. Using Hα images from the GONG El Teide telescope at 09:57 and 10:17 UT (upper panel in Figure 4), we tracked a visible feature and measured its projected motion in the plane of the sky. From the known geometry of the filament (footpoints identified on the solar disc), we converted the projected velocity to radial velocity using a simple geometric model. The result gives a radial velocity of 31 ± 7 km s⁻¹ at 10:07 UT. The same technique applied to STEREO‑A/EUVI 19.5 nm images yields 44 ± 5 km s⁻¹, providing cross‑validation (lower panel in Figure 4).

Figure 4: Upper panel: H image of El Teide at 09:57 UT (left) and 10:17 UT (right), April 15, 2023. The red circle shows the feature we track. Lower panel: 19.5 nm observation of EUVI-A at 10:05 UT (left) and 10:10 UT (right), 2023 April 15. The filament is in the same region as the upper panel. The red circle shows the feature we track.
Conclusion
We have presented the first dedicated off‑limb prominence observation by SPICE, analyzing the integrated intensity, line widths and line profiles of Lyman β and Lyman γ. The eruption causes spatial and temporal variations, with some regions becoming brighter than the solar disc. We also introduced a simple, fast geometric method to estimate radial velocity from two 2D images, which is particularly useful when other methods are limited to measure radial velocity. For the 15 April 2023 event, the radial velocity is ~40 km s⁻¹ at 10:07 UT. This work provides the observational foundation for upcoming non‑LTE radiative transfer modelling of the same event.
This nugget is based on the following work: https://academic.oup.com/mnras/article/546/3/stag104/8427326
Acknowledgements: Solar Orbiter is a space mission of international collaboration between ESA and NASA, operated by ESA. SPICE data used in this work are available via DOI: 10.48326/idoc.medoc.spice.5.0.
References
[1] Anderson, M., et al. (2020). Astronomy & Astrophysics, 642, A14.
[2] Dufresne, R., et al. (2024). Astrophysical Journal, 974(1), 71.
[3] McCauley, P. I., Su, Y. N., Schanche, N., Evans, K. E., Su, C., McKillop, S., & Reeves, K. K. (2015). Solar Physics, 290(6), 1703-1740.
[4] Zhang Y., Labrosse N., Parenti S., Kucera T. A., 2026, MNRAS, 546, stag104