Authors: James MCKEVITT,1,2 Sarah MATTHEWS,1 David H. BROOKS,3,1 Toshifumi SHIMIZU,4 Akiko TEI,5,6 Ignacio UGARTE-URRA,7 Shinsuke IMADA,8 Shin TORIUMI,4 Charles M. BROWN,7 Ryohko ISHIKAWA,5 Yukio KATSUKAWA,5 Hirohisa HARA,5 Duncan RUST,1 David WALTON,1 Berend WINTER,1 Deborah BAKER,1 Hamish REID,1 Peter R. YOUNG,9 Tiago M. D. PEREIRA,10,11 Louisa BRADLEY,1 Alexey SHITVOV,12 Louise HARRA,13,14 and International SOLAR-C team
Affiliations:
1University College London, Mullard Space Science Laboratory Holmbury St Mary, Dorking, Surrey, RH5 6NT, UK
2University of Vienna, Institute of Astrophysics, Türkenschanzstrasse, 17 Vienna A-1180, Austria
3Computational Physics, Inc., Springfield, VA 22151, USA
4Institute of Space and Astronautical Science, Japan Aerospace Exploration Agency, 3-1-1 Yoshinodai, Chuo-ku, Sagamihara, Kanagawa 229-8510, Japan
5National Astronomical Observatory of Japan, 2-21-1 Osawa, Mitaka, Tokyo 181-8588, Japan
6RIKEN Nishina Center,2-1 Hirosawa, Wako, Saitama 351-0198,Japan
7Space Science Division, Naval Research Laboratory, Washington, DC 20375, USA 8Department of Earth and Planetary Science, Graduate School of Science, The University of Tokyo, 7-3-1 Hongo, Bunkyo-ku, Tokyo 113-0033, Japan
9NASA Goddard Space Flight Center, Solar Physics Laboratory, Heliophysics Science Division, Greenbelt, MD 20771, USA
10Rosseland Centre for Solar Physics, University of Oslo, PB 1029 Blindern, 0315 Oslo, Norway
11Institute of Theoretical Astrophysics, University of Oslo, PB 1029 Blindern 0315 Oslo, Norway
12University College London, Department of Physics and Astronomy, Gower Street, London WC1E 6BT, UK
13Physikalisch-Meteorologisches Observatorium Davos/World Radiation Center, PMOD/WRC, Dorfstrasse 33, Davos Dorf, 7260, GR, Switzerland
14D-PHYS, ETH Zürich, Wolfgang-Pauli Strasse 27, Zürich, 8093, ZH, Switzerland
<< previous nugget — next nugget >>
Introduction
The processes responsible for heating the solar corona and triggering solar flares operate over small spatial scales, short timescales and a broad range of temperatures. These properties make them difficult to isolate using current spectroscopic instrumentation.
The upcoming SOLAR-C mission, led by JAXA and NAOJ with major contributions from NASA, ESA and European partners, will carry the EUV High-Throughput Spectroscopic Telescope (EUVST). EUVST is designed to observe plasma over approximately 0.02-15 MK, with spatial resolution down to around 0.4 arcsec – about 300 km at the Sun – and exposure times as short as 0.5 s. Its combination of spatial resolution, temporal cadence and temperature coverage will address two central questions: how the solar atmosphere is heated, and how it becomes unstable and releases energy through flares and eruptions (Shimizu et al. 2021).
In this work, we forward-model observations from the instrument’s short-wavelength camera, SOLAR-C/EUVST-SW, which covers 170.0-212.3 Å. The camera is a major UK hardware contribution, currently being developed at UCL-MSSL for ESA. The study investigates how well it will resolve coronal structures and plasma flows in a simulated pre-flare active region, and compares its expected performance with that of Hinode’s EUV Imaging Spectrometer, Hinode/EIS.

Figure 1: Comparison of simulated observations by Hinode/EIS 1 arcsec slit (left) and SOLAR-C/EUVST 0.4 arcsec slit with 2-pixel along-slit binning (right) of the Fe XII 195.119 Å emission line for a 40 s exposure per slit. This simulated observation uses one simulation snapshot ~30 min before a flare, where in reality the plasma would evolve beneath the spacecraft as the active region was scanned. This is discussed further in the paper.
Forward modelled EUVST observations of a simulated atmosphere
The study uses a three-dimensional active-region atmosphere produced with the MURaM radiative magnetohydrodynamic code. The simulation begins with a bipolar sunspot pair, into which a smaller, strongly twisted magnetic bipole emerges. Interaction between the emerging and pre-existing magnetic fields eventually forms a coronal flux rope and produces a flare-like eruption (Cheung et al. 2019).
The snapshot studied is taken approximately 30 minutes before the peak in simulated GOES X-ray emission. At this time, the model contains both relatively quiescent active-region loops and a magnetically complex pre-flare region above the newly emerged flux. This allowed us to test EUVST’s ability to observe ordinary active-region structures while also searching for signatures associated with flare triggering.
We synthesised the coronal (log T~6.2) Fe XII 195.119 Å line using the temperature, density and line-of-sight velocity in the three-dimensional atmosphere, and using the CHIANTI database (Del Zanna et al. 2021). A complete model of the short-wavelength channel then converts the simulated solar atmosphere into the detector output expected from the real instrument. Drawing on UCL-MSSL expertise across solar physics, optics, detectors and instrument engineering, the pipeline includes: spatial and spectral sampling, and the instrument 2D point-spread function; telescope and spectrograph throughput; photon-counting noise and detector quantum efficiency; dark current and noise, Fano noise and read-out noise; and electronic gain, digitisation and visible-light stray signal.
The resulting spectra are expressed in the same detector data numbers that EUVST will transmit to Earth. The same framework is also applied using the parameters of Hinode/EIS, enabling a direct comparison. The model is already informing mission development by quantifying trade-offs between spatial detail, spectral information, sensitivity and cadence.
Resolving active-region loops
The simulated active region contains several loop strands separated by only a few hundred kilometres. In synthetic Hinode/EIS observations, these structures blend together and appear as broader, only partially resolved loops. In contrast, SOLAR-C/EUVST distinguishes individual flux tubes within the loop system. It also resolves distinct flows in adjacent strands, including velocity reversals that may be signatures of siphon flows. In lower-intensity regions around the principal loops, EUVST recovers additional flow structure that is not detectable with Hinode/EIS.
Determining whether coronal loops contain a small number of relatively large strands or the hundreds of strands expected in some reconnection-driven nanoflare models is an important test of coronal-heating theories. These results show that, if active-region loops have substructure on scales only slightly below the limits of present instrumentation, EUVST should be capable of resolving it.

Figure 2: Comparison of simulated Fe XII 195.119 Å (log T~6.2) intensity measurements of coronal active region loops by Hinode/EIS (1 arcsec slit; top) and SOLAR-C/EUVST (0.4 arcsec slit with 2-pixel along slit binning; bottom). The loop strands resolved by SOLAR-C/EUVST are annotated (dashed lines).
Pre-flare plasma flows
The largest difference between the instruments appears in the pre-flare region above the emerging magnetic flux. SOLAR-C/EUVST resolves sharp gradients between adjacent upflowing and downflowing plasma, including a transition separated by only around 300 km. The simulated EUVST observations recover velocities from approximately -60 to +40 km/s, representative of the original MHD simulation. Hinode/EIS smooths these neighbouring flows together due to a lower spatial resolution and wider spatial PSF. It measures a range of only around -35 to +5 km/s – approximately half the true velocity range – and reduces a resolved downflow of about 40 km/s to around 5 km/s.
The oppositely directed flows are found above the newly emerged flux that triggers the simulated flare. They are consistent with upflows and downflows produced by low-altitude reconnection between emerging and pre-existing magnetic fields. EUVST may therefore be able to observe local reconnection associated with flare triggering directly, and potentially detect pre-flare upflows earlier than is possible with Hinode/EIS.

Figure 3: Comparison of simulated Fe XII 195.119 Å (log T~6.2) Doppler velocity measurements of pre-flare coronal plasma by Hinode/EIS (1 arcsec slit; top) and SOLAR-C/EUVST (0.2 arcsec slit; bottom). The final simulated instrument spectral profiles for a 40 s exposure per slit position in DN/pixel were fitted.
We have released the complete forward-modelling pipeline ECLIPSE – Emission Calculation and Line Prediction for SOLAR-C EUVST. The open Python tool allows researchers to simulate observations, explore instrument performance, test observing strategies and begin planning the science programmes that will be carried out after launch. This is a further UK contribution to mission readiness, turning UCL-MSSL’s instrument knowledge into a resource for the wider international community.
Publication link: https://academic.oup.com/pasj/advance-article/doi/10.1093/pasj/psag078/8731000
ECLIPSE forward-modelling code: https://github.com/jamesmckevitt/eclipse
References:
- Cheung, M. C. M. et al. (2019). A comprehensive three-dimensional radiative magnetohydrodynamic simulation of a solar flare. Nature Astronomy, 3, 160–166.
- Del Zanna, G., Dere, K. P., Young, P. R. & Landi, E. (2021). CHIANTI – an atomic database for emission lines, version 10. Astrophysical Journal, 909, 38.
- Shimizu, T. et al. (2021). The SOLAR-C EUV High-Throughput Spectroscopic Telescope (EUVST). Proceedings of SPIE, 11444, 114440N.